Search results

  1. A

    1993 johnson 150 engine block rebuild question

    i am getting ready to rebuild my johnson j150elatr. The block cracked on my original engine. I called ********** and i know that the 150 block is obsolete. I am aware that they are the same block as 175. i gave them my original block part number(432999) they sent me a replacement block part...
  2. A

    1993 johnson 150 block cracked

    The block has cracked on my 150 I would just replace the engine but in the past year I have replaced lower unit replaced power pack rebuilt all the carbs and some other part replacements. The boat is to nice to scrap any ideas or no anyone that has an engine block or maybe an engine with blown...
  3. A

    1993 javelin livewell slow recirculating

    I have a 93 javelin bass boat. It has a divided livewell. It has 2 fill pumps and 2 areator/recirculating pumps. Here is the problem. When i have it in manual recirculate everything pumps fine. When i switch to timed recirculate the water stream that pumps out is drastically reduced. I would say...
  4. A

    1993 johnson 150 starter wont engage flywheel

    Ok just a little history I have cleaned all my connections I have new cables from battery to motor. I have taken flywheel cover off and taken the gear off top of starter(bendix I think its called) I have cleaned it. It was a bit dirty. I cleaned it with parts cleaner thoroughly I have oiled it...
  5. A

    1993 johnson 150 ELATR lower unit rebuild

    long story short pulled my lower unit oil drain plug and got white milky oil so i knew my seal were shot so i took it to the shop to have seals replaced. Shop called today and told me that my lower unit was a time bomb. Forward and reverse gear were missing teeth. My question is how hard is it...
  6. A

    1993 johnson shift control arm has a lot of play

    I have posted before here with much help so here i will try again. 1993 javelin 379t with 1993 johnson 150 siver series(elatr model) The shift control has a lot of play from side to side. I can move the arm in and out at least 1/2" to 3/4" i know the control box is on the backside inside the...
  7. A

    1993 johnson 150 will not run over 3500 rpm

    I am new here and have searched this problem out but no clear answer as it probably is not one. Motor is a 1993 johnson silver series model #vj150elatr. Here is problem crank motor let warm up for minute or two give it full throttle engine runs fine(5000-5200rpm) but come off plane and idle for...
Top