Search results

  1. D

    1990 Aquasport Osprey baitwell plumbing HELP

    Trying to Plumb my boats built in bait well. Bait well is located under front seat directly in front of the center console I have installed a 800gph rule pump and ran a 1" line from the pump to the water in nozzle. The problem is where to run the drain line. Should the drain be located in...
  2. D

    Shift Rod O-Ring Goes Where?

    Ok its a 1986 1990 Evinrude 120 long shaft. I got water getting into lower unit. So I have replaced the oil seals on the drive shaft, and was going to replace O ring on the shift rod but the schematics show an o ring under the cap. I cant figure out what good putting an o ring under the cap...
  3. D

    1986 Evinrude 120 Deflectors.

    Does anyone know if my 1986 evinrude 120 has deflectors like in my old 1990 88spl? I had similar issues and as soon as I changed those deflectors issue resolved. Have replaced thermostats and impeller, alarm sounds for the first couple minutes, keep my eye on temp gauge, temp drops rapidly and...
  4. D

    1986 Evinrude 120hp Steering Arm Assembly Removal and Replacement, worth it?

    I have now had two local marinas tell me that you gotta take the powerhead off to replace the steering arm assembly. I guess these are notorious for rotting off? Now Looking at this thing I can only see Six bolts that hold the Motor on to the swivel bracket. Why on earth would you remove the...
  5. D

    1986 evinrude 120 stering arm assy. Help

    I got a nasty looking steering arm really thin and rusted up top and I kinda dont even want to touch the bottom, new price is yikes $700 and I've heard that you gotta remove the powerhead to replace it. Question is are they available used and if so is it worth the work to replace it? Any advice...
  6. D

    1990 88 SPL overheat alarm when full throttle HELP

    OK I have replaced: Impeller, plugs, wires, thermostats, fuel pump, she is running great except after about 30 seconds at full throttle the overheat alarm goes off and if I back it down to idle it goes off in about 10 seconds. **** stream is good seems like pump is working as it should. Do the...
  7. D

    Does anyone know the float measurements for 1990 88 spl ?

    I got the drop measurement from the Cymler manual but its calling for a special tool to set the rise. Any body know what that measurement would be?
  8. D

    1990 Johnson 88 spl bogging down when full throttle??

    I got a "free" boat from a friend of a friend, just about a thousand bucks into it now and got most of the bugs out. Cleaned the carbs, replaced the starter, new plugs, drained the fuel, replaced impeller, replaced lower unit lube. Its got good compression, good spark starts good, idles good...
Top