Search results

  1. C

    1974 500 50HP Internal wiring, how many wires

    I've kind of hit a snag with the internal harness for the motor. It has the classic rotten wires and corrosion through out the internal harness, I've already done a chop job once a few years back and cut the wire back to good but now the brittle wires and shorts are back so I figured I would...
  2. C

    Starter not starting

    Hey all, been working on a '84 115 inline for a while now, It was dry for quiet some time prior to me working with it. Anyway always seemed to crank right over without a problem, but the water pump was bad so i never really ran it. So I replaced the wp last week change the fluid and had also...
  3. C

    Long and short

    Did Merc make a long and short shaft of the 84' 115 inline and if so , How long is each one. I think there was both a 20'' and a 25'' but not sure. Also this measurement is taken from the anticav plate to the ? . Thanks
  4. C

    56' 30 Seahorse water pump

    I've got a 56' 30 hp seahorse, that was sitting for a while(3yrs give or take a month or two) , when I fired it over there was no pee, so I figured water pump right, Well I replaced it, the housing was in good shape no cracks, no splits no problems at all. So I just replaced the impeller, The...
  5. C

    56' Seahorse 30 needs parts

    Anybody point me towards a part list for a 56' Seahorse 30, and maybe where to get the parts. I know I'm in need of gears as it has started to buck and little bit under power (just at the high end though) and is starting to slip. :( A general parts list would be nice as to maybe replace a few...
  6. C

    Ignition Switch -Switch

    I have avery similair problem, only with a 6 wire switch. The old switch works great ,problem is the treads for the coller nut broke off anyway. The old terminals are labeled. B,M,A,M,S,C I'm going to assume that the C-is the choke as the switch was a push to choke, and the rest are the same...
Top