Search results

  1. F

    Trolling motor toss up

    I have little foot room in my Lund Fury 16 ft fishing boat. Am looking at a hand operated bow mount motor. I need 45 lbs + 45 inch shaft. Motorguide+ Minnkota each make one. Anyone have an oppinion as to which is a better product. I'm sure their both good but any features or things I should know...
  2. F

    Windshield brace

    I have added a windshield to a Lund Fury. Any ideas on what might work to support one side? The council is small and the side of the dash has an angle to it. I only need one brace. Thanks
  3. F

    Switch panels

    Does anyone know if you can use the seasense 6 gang switch panel horizontally? It is shown vertical. I assume you can just switch the labels around. I have such little room on the dash. That panel seems like a good one. I have a small council on a 16 ft Lund Fury. Any other suggestions on switch...
  4. F

    What switch panel to use?

    I am rewiring a 16 foot Lund Fury and don't know much about wiring. Any recomendations as to what switch panels are best for my application? I want to use a 6 gang panel with led back lighting. The wiring info on this site has been very helpful. Also I've been told that boat fires may occure if...
  5. F

    rivets used on the inside remodel of a Lund Fury.

    Does anyone know if I can use a standard type rivet gun to fasten areas around the bilge and carpet areas. Also do I need to use special rivets since these areas are not in water? The ones I removed were pretty heavey duty as to the type I usually use w/ my gun.
  6. F

    Johnson 40 horse

    Bought the boat with a lot of repair needed however the motor seemed in good shape. A local marina went thru it and said it ran well but when I started it alot of oil ran out of the prop area. Will a new impellar kit be necessary? The marina said sometimes when they sit a long time they might...
  7. F

    2 part foam

    Is it alright to use 2#pour in foam in a 16 foot aluminum lund boat? Will it be dense enough or will it absorb too much water over time? I am leaving a path down the middle for any water to drain to the bilge should it get in the hull.
  8. F

    Closed cell foam in a Lund Fury 16"

    After a great deal of research and great input and ideas from those of you that know, I have a better understanding of what to do for replacing the foam in the hull of my aluminum boat. I was already to order the 2 part foam on line and then I called a local foam installer and he said he could...
  9. F

    Restore Lund Fury

    Can't seem to get the water out of the foam at rear of boat after removing old deck material. Had a fan on it for days. Can it be removed and replaced with something else, spray or block foam? Don't want to mold to start. I have a Lund Fury 16 ft. restoration project.
Top