Search results

  1. J

    Flushing Salt Water

    Hello, I have a 240 Mercury coupled to a jet drive (Sea Doo Islandia). If it stays in the water after use, what's the proper procedure for flushing? Just run the hose without the motor running? Will running the motor while flushing suck up salt water? It has a hose connection in the engine...
  2. J

    New Motor Rough Idle

    Hello, I took my SeaDoo Islandia 240 Mercury out for the first time after the rebuild. It seemed to run rough at idle (a lot of "thumping'). I did bypass the oil injection and running a 25:1 ratio for the break-in period. Without the oil injection, it gets this string dose at idle instead of...
  3. J

    sealant

    I'm replacing a steering cable that goes through the hull and Mercury calls for the use of Perfect Seal 92-34227-1 I guess it different then any type of marine sealant because it doesn't dry out or harden (perhaps like teflon paste). If there something else that can be used in it's place...
  4. J

    Tiny Tach vs Quicksilver Service Monitor

    Hello, It's seems as though the Quicksilver Service Monitor is manufactured by Tiny Tach. Is this correct? If so, are the specs for the Quicksilver version the same as the Tiny Tach? I've read the Quicksilver can read the RPM's and has a re-settable job meter, but does it also record the total...
  5. J

    Tiny Fuel Lines

    Hello, On my 2002 Islandia with a 240 Mercury, there is a very small fuel line, probably about 3/16 OD, that connects to three 1/8" barbed connections on the starboard side then loops over the top and connects to two 1/8" barbed connections on the port side. It looks like the throttle body /...
Top