Search results

  1. Tail_Gunner

    My new to me 186 ss/s

    Back in July of 06 i ran across this little beauty quite by accident......Just to make a long story short it was lost in inventory for 5 years Sitting so long it's had some issue's but the most amazing thing i could imagine happened...... since it was a new boat Wellcraft has honored the new...
  2. Tail_Gunner

    Well it's to boring so i redecorated

    It should be self explanatory..........this winter is going to be expensive . ------------------------------------------------------------------------ As you can see this dog house is eating up a bit to much room here so it's to to size him down a little. 6" inch cut Quick...
  3. Tail_Gunner

    The danger's of a liberal mind.

    http://www.spinmaster.com/product.php?productid=16174&s=rocket&xid=398955d70cf558f99457adad60278148
  4. Tail_Gunner

    Gel replacing carpeted floor..... Psst ondarvr

    I have been seriously thinking about pulling up the carpet on a boat and gelling the floor, what has tempered my enthusiasm is finishing the floor (sanding) to a acceptable level. Cruising restoration's i came across the ideal of just laying down a plastic or polymer sheet and eliminating...
  5. Tail_Gunner

    Is this America Is this the democratic party?

    Is this America Is this the democratic party? http://www.msnbc.msn.com/id/15769199/ :'(
  6. Tail_Gunner

    The lighter side

    http://www.youtube.com/watch?v=mMMiZWMcP-A
  7. Tail_Gunner

    Can your's do this?

    http://www.youtube.com/watch?v=ZYn8SZTr_j8
  8. Tail_Gunner

    Resolving Political DiscoursePage

    Is this you...........if so take a breather............................ http://forums.iboats.com/bbBoard.cgi?a=viewthread;fid=20;gtid=1189284
  9. Tail_Gunner

    Wellcraft's new forum

    Wellcraft has started a new forum, im sure in time it will be full of info, pic's and good old smack talk.........8) http://www.wellcraft.com/forums/
  10. Tail_Gunner

    The noob 4.3 thread (EFI)

    The noob 4.3 thread (EFI) I am having my first good look for the first time @ this new 4.3 engine boat combo i have (It reminds why i don't sell chevy's) anyway's iv'e noticed that the air intakes do not open @ idle or @ high speed took a shot of them @ 2000 rpm just slighly open. WHy in...
  11. Tail_Gunner

    Stern or Prop issue On 90 turns

    Just as she states, put a new prop on it ( 4 blade ss which i am very satisfied with) and it has begun to or something has begun to create a fairly good rumble....oscilation type of nosie on either a hard right or left turn while running @ very low rpm. And yes im trimmed all the down, trim...
  12. Tail_Gunner

    2001 volvo temps & plug's 4.3 Efi.

    It has been 25 years since i have changed plugs, :devil: only broke two takem out, gotem all back in without a hitch........Crosses fingers......o:) But what i found was for a car motor a little different. Look's to me like a way overrich condition, i have also noticed my temp gauge showing only...
  13. Tail_Gunner

    Jdeagro Some trim tab advice plz

    Iv'e gotten myself into a little project here, and it involve's some chine waik or some kind of stabilty issue.(left to right wobble) Trying to be short, new prop 4bl type has so much overall lift @ 54mph and above i experiance the above problem and am hoping the tabs will dampen this...
  14. Tail_Gunner

    Tapping into the existing fuel tank

    I'm about to put a kicker on my I/O, it has a 34 gallon tank and if i have read it right there are two fuel pumps, one to draw the fuel to the fuel filter and one to pressurize the efi. Im planning to try and tap the low pressure side, any thought's or suggestion's here.......... i just do...
  15. Tail_Gunner

    Hull strakes

    Just noticed that wellcraft put one strake line all the way down the boat about 1' off the keel, second strake run's only for the first 7' from the bow and end's. (6" above the keel) This thing has a complete mind of it's own @ the ramp,( wander's worse than any of my kids) could this be one of...
  16. Tail_Gunner

    Pressure wave

    Dhadley or Walleyehed in your constant dilagence for spec's, aka wot speed rpm are you guy's trying to determine the type of pressure wave the hull create's and the prop live's in? aka bow lifter, stern lifter, why one prop works on one boat lenght and yet not another? Ive been doing some...
  17. Tail_Gunner

    Fogging a fuel injected motor

    01 4.3 efi, will fogging this motor have any long term effects on the sensor's, maybe a silly question, but i would like to avoid been there done that and know the answer.....in a negative light.
  18. Tail_Gunner

    Breaking in procedure revistited

    Posting this topic is not meant to be contraversail, i am looking for a litte more insight into the process. Personally i have broken in new car's for the past 15 years (demo's every 6 months) and have found that if you do run them hard for the first 1500 to 3000 miles they do run stronger and...
  19. Tail_Gunner

    Don't get in this boat's way

    http://koti.mbnet.fi/~soldier/towboat.htm ok try this one, the link is at the bottom of the story page. http://koti.mbnet.fi/~soldier/index.html
  20. Tail_Gunner

    Crazy Stilletto prop question

    Trying to make a long story short i have a new Stilletto 20 pitch 4 blade that's setup for mercruiser. I now have a volvo sx drive and am sitting here looking at this prop collecting dust. I was wondering if Prec could press in a volvo hub into this prop .........wild reach here but i am going...
Top