Search results

  1. Grub54891

    Bathroom (head) caulk

    As Scott said. I've used lifecaulk on several and it holds up well.
  2. Grub54891

    Bottom cylinder sounds bad 1997 evinrude 3 cylinder

    Had one in the shop, the boss had overhauled it, sold it. It came back blown up again. The middle cylinder both times. He had me tear it down ti investigate, At first I didn't see anything that stood out. As I was re-assembling I was looking at the flywheel and the timing ring didn't look right...
  3. Grub54891

    Reverse Polarity and no battery charge related?

    Yes. Disconnect the hard wiring from the devices. Turning off the breakers doesn’t work.
  4. Grub54891

    Grassl glass

    Didn't dig to deep but found this? https://www.bizapedia.com/ny/grassl-glass-boats-inc.html
  5. Grub54891

    Reverse Polarity and no battery charge related?

    Weird. Usually find it with the cord itself or a dock pedestal. Could be the boat itself, We have found a common place is a water heater either wired incorrectly or the element is starting to go south even though it still works. To find it you have to actually disconnect the wires from the...
  6. Grub54891

    Reverse Polarity and no battery charge related?

    Did you try plugging it in a different spot?
  7. Grub54891

    1970s winday day cruise foam core deck

    I prefer to use the top layer as it’s already made to fit and helps keep the original look. if you have to re-do the edges of the cut you can just blend it in like a non skid 1-2” wide strip around it.
  8. Grub54891

    Cold engine despite running for a while. Water entering bilge

    Rust chips will be all over the cooling system. Inside the block also. Only way to get most of them out is to remove the core plugs and flush the heck out of the block itself.
  9. Grub54891

    Gear Oil In My Bilge

    the water leaking out under the manifold is typically where 3.0s freeze crack you may see with a mirror or have to remove the manifold. That area where head and block meet it the top of the water jacket on block and typically where 3.0s crack. Do you have water in the engine oil Mine had that...
  10. Grub54891

    Sealegs don't lift high enough with Frame/Canopy setup

    get longer legs? Or fabricate something to make them longer and pinned to be easily removable when conditions allow.
  11. Grub54891

    Commonality with Auto Works

    My old saturn, Window, controll has electric fir the passenger and back doors. Drivers door has a crank? I know the car was never on an accident and had the door replaced.......
  12. Grub54891

    1970s winday day cruise foam core deck

    If at all possible, some decks are screwed down. I prefer to remove and do the work from the bottom side. Thats if it's screwed down. Hope it is for you!
  13. Grub54891

    The special toolbox drawer

    I have a sacrificial wrench box that I get from garage sales. I'm not cutting up mp my good wrenches!
  14. Grub54891

    Tips On Replacing Starter

    Tie a string/small rope to it. Tie off the rope and it’ll hold it up so you can remove and install the bolts.
  15. Grub54891

    I was over due for this to happen.

    Have to figure out how the water got in there. Portable cans have a vent on the cap, it lets water in if left open. My neighbors pontoon had water issues twice. Got it all cleaned out and told them to close the vent when done for the day. Two weeks later, same thing. They left the cap loose and...
  16. Grub54891

    Stupid me, no oil

    Had a leak on the intake myself. Had the heads re-done and they milled them flat. I used the end gaskets for the intake that came with the kit. Turns out when you shave the heads, the gasket is too thick. It squished out. My fix was to remove the remains of the gasket without removing the intake...
  17. Grub54891

    Tips On Replacing Starter

    That video was a bit funny. On a 120-140 it's easier than a v-8. I've taken and tied a 1/4" line to starters, drug them through the bilge after cleaning the bilge and pulled the starter up in place with the string. Then lay on your belly and screw around getting the bolts in. Never had to pull a...
  18. Grub54891

    Where did my oil go?

    Person needing a job at below minimum wages. And they have no abilities ????? Ah yes. We hire people who claim to know what they are doing, but it dosent always work out. Pay is a fair amount above min wage but these people fluff their applications up a bit too much. Within a week we get them...
  19. Grub54891

    Where did my oil go?

    Glad you got it fixed. Note to self, never take a previous owner for his word. I just got rid of a 21’ Sylvan that I acquired for fre, no known history. The guy I gave it to,I told him that I don’t know anything about it, he checked it over, took it out on Lake Superior three times. About 60...
  20. Grub54891

    Broken gear lube fitting

    if my boat had the ez drain, I’d remove it.
Top