Search results

  1. 1

    mercruiser 7.4 (L29) firing order

    Maybe I'm Maybe I'm having a brain fart. But my manual shows #8 as the rear most (toward the transom) point on the distributor. Tpen and other quick searches online show #8 as the front most pin. I'm wondering why they're esentially opposites.
  2. 1

    mercruiser 7.4 (L29) firing order

    I have not. But if im going to pull it off I might as well replace the cap and rotor while I'm there
  3. 1

    mercruiser 7.4 (L29) firing order

    I guess my concern was if they previous owner had it set on tdc for exhaust the rotor could be 180* from where it should be.
  4. 1

    mercruiser 7.4 (L29) firing order

    I did yours seems completely opposite of mine.
  5. 1

    mercruiser 7.4 (L29) firing order

    I used a inline tester and had spark on all points. I did put an order in for a cap and rotor. Figure I might as well do that now.
  6. 1

    mercruiser 7.4 (L29) firing order

    Distributor has not been off. Pulled wires and plugs and put new ones on. Then reran all the wires as the manual stated. Knowing I was replacing the wires I didn't check the order they were in when I pulled them off the cap. Just figured I would go by the service manual.
  7. 1

    mercruiser 7.4 (L29) firing order

    Yes. I actually went back to the previous coil that was in when the boat ran (but misfired). Could the previous owner have installed the rotor 180*?
  8. 1

    mercruiser 7.4 (L29) firing order

    Hey everyone. I have a 1999 mercruiser 7.4 (L29) engine in my sea ray that I've been having issues with. Part of the problem was a backfire thst was persistent and low power. I replaced the plugs and coil and rewired it, now it won't fire off. I was using the mercruiser manual: My plug...
  9. 1

    1999 7.4mpi cold start won't idle

    That's unfortunate. I really thought it running perfectly on the trailer every would be good. Now we're back to square one. Maybe replace the impeller, get water through her and see if she'll idle warm again? Does anyone rent those scanners? 600 dollars and only being compatible with that mefi...
  10. 1

    1999 7.4mpi cold start won't idle

    Hey guys, This will be a little winded backstop but might be helpful. New question. I bought a 1999 sea ray with a 7.4 mpi mercruiser (l29) from a guy that had issues getting it run. Replaced the iac and got it running last year enough to winterize it since it was already mid October. Fast...
  11. 1

    1999 mercruiser 7.4 exhaust tube source?

    Next question would be....where can I buy generic exhaust hose online? There's no real local places to me.
  12. 1

    1999 mercruiser 7.4 exhaust tube source?

    Will a 4" work with the oval y pipes though?
  13. 1

    1999 mercruiser 7.4 exhaust tube source?

    I tried readjusting all the hoses. Same deal. Looks like it's been that way for a while though. If I can get 2 clamps on the corsa split, I can barely get 1 one the y pipe, and vice versa.
  14. 1

    1999 mercruiser 7.4 exhaust tube source?

    Hey all. Picked up a new to me 1999 sea ray with a 7.4 mercruiser, bravo 3 drive and corsa captains choice exhaust. I ran into a problem first time out. Water leaking out the rubber between the corsa pipes the y pipe. It looks like the top of the rubber to the corsa pipe is barely attached. 2...
  15. 1

    how to pull codes/information?

    Hey guys, We have a 1997 Albemarle that has the twin Volvo Penta/Ford 5.8L motors. The motors were built in 1995 (pre ODBII). I have a code scanner (I'm a mechanic, so its used in my auto shop) and used it with the Ford plug, however I couldn't pull any info. Is there any reason that marine...
  16. 1

    1997 Volvo 5.8 rev problem.

    Hey everyone. Just thought I'd ask as I'm completely stumped. I have a 1997 Albemarle with twin Volvo 5.8 FI motors (charcoal colored). They are inboards. I've been having problems with my starboard side motor. First off, it's always had this issue where the tachometer, when running out our...
Top