Search results

  1. P

    2hp evenruide rope problem

    I went to start my 1972 2hp evenruide and on pull number 3 i could hear something grinding as i went to pull. Then i could not get the rope to retract back. I took the cowling off and inspected the pawl along with the rope, but everything looked okay. It sounds like something is grinding in the...
  2. P

    2hp evenruide decarbing

    I have did the decarbing procedure with the seafoam.now my outboard is running rougher then before. I pulled the sparkplug and it looks okay. I drained the seafoam mix and put in fresh gas with oil still running a little rough and smoking. Any ideas or tips
  3. P

    2 hp evenruide

    Hey guys i just finished putting on a new coil, condensor, cleaned the points and installed a new plug wire. It fired up really good after a few pulls with the choke out. I can get it to idle on the start position really good, but when i start to idle it down at a low idle it will idle for about...
  4. P

    help with a 2hp evenruide

    I have a 1972 2hp evenruide i just purchased. I took the flywheel off and replaced everything . The coil, points and the condensor. I placed the flywheel back on and torqued it to 24lbs. I went to pull start it and the rope will not budge. I tried to turn the prop and would not budge also. I...
  5. P

    1972 2hp evenruide

    I just purchased this motor and ran it in a barrell for about 15 minutes. It starts fairly easy when its cold (3-5) pulls and it idles really good at low rpms, but when its warmed up its a pain to start. I pulled the spark plug and it had a champion j8c in it. Is it possible that the plug is...
  6. P

    1972 evenruide 2hp

    Hey guys this is my first outboard and im currently trying to get it tuned up for some duck hunting this winter. I just purchased the motor off of ebay and when it came home i noticed it had a big blob of jb weld on the side of it. The jb weld is huge and sticks out quite a bit from the lower...
  7. P

    1972 lower unit

    Im just curious if a 1980 2hp evenruide lower unit will fit a 1972 model. Thanks.
  8. P

    1972 2hp evenruide

    Hey guys this is my first outboard to ever own, so i dont know a whole lot about them. I bought this old motor and replaced the water impellar and the gear lube. I took it out to the lake and it ran fine at low speeds, but when i idled up it seems like its slipping or something. The rpm's would...
Top