Search results

  1. C

    1962 evinrude fatwin 18hp carb settings.

    112 both cylinders
  2. C

    1962 evinrude fatwin 18hp carb settings.

    What is the best way to get the flywheel off.I know it usually requires a special tool.will screwdrivers and a maiiet work.Do you have to take the 4 screws off holding the plate on top of the flywheel
  3. C

    1962 evinrude fatwin 18hp carb settings.

    The carb looked good inside no varnish or crud .I got a kit anyway
  4. C

    1962 evinrude fatwin 18hp carb settings.

    I ment to say the foot oil had no water in it
  5. C

    1962 evinrude fatwin 18hp carb settings.

    You are right I was looking at the choke knob.I had a brain fart
  6. C

    1962 evinrude fatwin 18hp carb settings.

    I usually buy a factory omc manuel but 1965 was the earliest I found.
  7. C

    1962 evinrude fatwin 18hp carb settings.

    I just got it at an estate sale saturday.I have no clue.Its a nice looking motor.I have the foot off changing the impeller.I pressurized it and it held 12lbs for 30 minutes .The foot grease had no oil in it.The fuel lines were hard and I do not imagine it has run in a very long time.I poured atf...
  8. C

    1962 evinrude fatwin 18hp carb settings.

    The high ,low and other jet
  9. C

    1962 evinrude fastwinn 18 hp.Which fuel line goes to the pump?The one close to the block or the ot

    No arrows that I saw
  10. C

    1976 456hh 45 hp.magneto model

    Sorry for the late reply .I finally got some new coils as mercury made some.I relaced both and the Ole 45 is running great thanks everyone for the help
  11. C

    1962 evinrude fastwinn 18 hp.Which fuel line goes to the pump?The one close to the block or the ot

  12. C

    1976 456hh 45 hp.magneto model

    I clean them and reuse them.I keep some extra in all my boats.They are reuseable
  13. C

    1976 456hh 45 hp.magneto model

    I have 2 coils ordered they were paid for on Oct 10.I don't think they are even shipped yet
  14. C

    1976 456hh 45 hp.magneto model

    I checked the compression.I warmed it up idling it.The compression is 110 on both cylinders.I will have to get some help to check the spark
  15. C

    1976 456hh 45 hp.magneto model

    Will changing the plug correct this .As soon as I change the plug it runs on both cylinders.i changed it on the water the other night and it corrected it
  16. C

    1976 456hh 45 hp.magneto model

  17. C

    1976 456hh 45 hp.magneto model

    There are cracks on the coils
  18. C

    1976 collins craft.I have the boat off trailer and upside down.It has been washed with muritic acid.I am going to sand with 80 grit and use 2 part

    Don't know if I have the enough experiance to re gel coat.re fiberglassing the damage is no issue.I was looking to paint with a 2 part epoxy hard paint but don't know if this will work or not
  19. C

    1976 456hh 45 hp.magneto model

    I assume coil is good if you change top plug it's an instant fix
  20. C

    1976 456hh 45 hp.magneto model

    I mostly run at full throttle.I assume it's fouling the plug although they don't look fouled..I'm running 92 octane no ethanol 50 to 1.Plug runs fine after cleaning .Gas is fresh also.Coils are on the outside of motor .Would this be a magneto model.It has no cdi box
Top