Search results

  1. M

    Nissan ns9.9 2 stroke ignition wire question

    I had both plug leads off now can't remember if the spark plug wire coming out of the right side of the coil goes to the top or bottom cylinder? Oops
  2. M

    Add cleat to trailer?

    Can you share the glass shop info. Looking to restore the luster in my wellcraft
  3. M

    Add cleat to trailer?

    This seems perfect thanks
  4. M

    Yamaha 704 binnacle remote question

    Usa
  5. M

    Johnson 25 hp hood part needed

    Just the plastic plate with the 25 on it
  6. M

    Yamaha 704 binnacle remote question

    Looks like that interlock controller is yamaha. Eu Not sure we can get that here
  7. M

    Yamaha 704 binnacle remote question

    Ok where did you find that?
  8. M

    Johnson 25 hp hood part needed

    Anyone know where to find a good one of these? Discontinued
  9. M

    Add cleat to trailer?

    Yep. Makes sense
  10. M

    Yamaha 704 binnacle remote question

    Where does one find this style?
  11. M

    Yamaha 704 binnacle remote question

    Hi 2001 yamaha 130 v4. New yamaha control cables and 704 binnacle remote. Any way to get a more positive feel in neutral? What happens is when you go from forward to neutral it is very subtle. If not paying close attention you can overshoot it and go to reverse. I tried increasing the friction...
  12. M

    Add cleat to trailer?

    Line on the stern one on bow, once boat is floating pull it over to dock by hand. To load it you pull it over to the trailer by hand
  13. M

    Add cleat to trailer?

    Believe it or not I've never driven a boat off or on a trailer and I've owned close to 10 boats over 25 years. But yeah I get the idea. Thanks
  14. M

    Add cleat to trailer?

    I noticed when I launch my boat off my roller trailer it takes the winch strap very far with it as it's coming off the trailer. I have a bow line tied to the boat but I can't undue the winch strap until the tension is gone which is usually far down the trailer. What's the thoughts on putting a...
  15. M

    Nissan 9.9 2 stroke stuck lower unit

    Driveshaft wasn't stuck at all. Here's a pic of the powerhead lifting off. Top of shaft is ok. Lower is still stuck on.
  16. M

    Nissan 9.9 2 stroke stuck lower unit

    Well. There goes the casting. Broke a big chunk off the lower unit. Going to part out what's left. Anyone know if the 9.8 2 stroke shares most of the same parts with this 9.9 2 stroke?
  17. M

    Nissan 9.9 2 stroke stuck lower unit

    No way around that scenario?
  18. M

    Nissan 9.9 2 stroke stuck lower unit

    Trying to remove lower unit. It uses 4 studs and nuts. I've been soaking the stud area and all around the parting line of the unit to exhaust housing for a week. Tried heating the area around the studs. It won't even drop enough to get a screwdriver between them. I tried hitting the lower unit...
  19. M

    Yamaha 130 v4 idle mix screws

    Wow. Very thorough. Thank you
  20. M

    Yamaha 130 v4 idle mix screws

    My 2001 130 v4 loads up when running at a fast idle say 1100 to 1500 rpm range. It doesn't stall but you can tell it's not as smooth as it should be. I set the screws to factory spec bur may need some finite adjustments? On my last 115 v4 I remember not noticing a perceived change when adjusting...
Top