I have an Evinrude1961 75 hp 50525, this is the long reach motor. I am trying to convert to the short reach (50524) without the extension. Water tubes, drive shaft and shift rod are all too long. I also have a 1963 Johnson V4S 15R also 75HP this is a short shaft version basically same i picked...
I have two wires coming through the wire harness into the engine that are not attached to anything. Are those the leads that have to be attached somewhere to wire the Tach? The Tack is an old airguide P-5079 or 653 if that matters. the harness has 4GA red and black, brown, white, and 2 black...
I have removed the water pump on my 1961 75HP Evinrude # 50525. The last person I am guessing, to do this job did not take the stainless cup insert out of the old and install to the new one. I assume this may be a problem? Is the cup insert available? Its not listed as its own part # in any...
I am sure someone has addressed this; trying to install a new water pump on 75 HP 1961 Evinrude Starflite 111 and I can't seem to locate how and where to disconnect the shift rod so I can drop the lower unit. It looks like it could be by the grease fitting where the lower linkage attaches...