1961 evenrude 75 HP 50525 disconecting the shift rod?

utah lakes

Cadet
Thread starter
Joined
May 31, 2016
Messages
8
I am sure someone has addressed this; trying to install a new water pump on 75 HP 1961 Evinrude Starflite 111 and I can't seem to locate how and where to disconnect the shift rod so I can drop the lower unit. It looks like it could be by the grease fitting where the lower linkage attaches underneath the cowling ? I have read it may be behind the carbs but that does not appear to be correct. any help out there would be greatly appreciated?
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
Small panel on the side of the motor leg with two slotted screws. Remove it. Smaller panel inside there. Remove it. Should reveal the shift rod coupling. Remove one of the bolts (one or two may be visible depending on whether long or short shaft). Do not remove the coupling bolt with the lower unit hanging by the shift rod as it will wipe the threads off the bolt.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Look about half way down and you will see a plate held on by two screws. Remove that plate. Behind it, you will find another plate held on by two screws. Remove that one too. Inside, behind the second plate is the brass shift rod connector. Remove the lower bolt from it. Now you are ready to drop the lower unit.

Warning! When you put it back together, use a flashlight to peer in there and make sure the notch in the shift rod is exactly aligned with the screw hole in the brass connector before inserting the bolt. Failure to do so will cause the bolt threads to drag on the edge of the notch, wiping the threads off the bolt. Then it will fall out. But never at dockside, rather always 5 miles out.
 

utah lakes

Cadet
Thread starter
Joined
May 31, 2016
Messages
8
Thank you, knowing what I was looking for made all the difference. While I am doing the Water Pump anything else I should be doing while I am there. Everything appears to be working and in good shape, considering. Two gasket ?'s the large one between the unit that separated when I dropped the unit and a gasket between the cover plate and the inside cover plate that exposed the shift rod connector both shot, can I just use Permatex / Loctite form a gasket red or blue, Those would likely be hard to come by and likely expensive? also when putting the new rubber rotor on, should that mount flush with the cover plate below or should there be a gap underneath of about 1/4 inch. the key prohibits it from sitting flush it would appear.
 
Last edited:

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
The large gasket atop the gearcase is no longer used. Clean up the castings and put it together without the gasket. The small access cover gasket needs to be reasonably well sealed to keep smoke from entering the motor cover. Any gasket goop will do.

Speaking of smoke, there is a seal on top of the water pump. That seal has to be doing its job, or smoke will enter under the motor cover, making the motor run lousy, and drive you nuts trying to figure out why.
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
The pump impeller sits flush on top of the base plate - NO GAP. If the key is keeping it from seating, then something is bound up - wrong impeller, key not seated, etc.
 
Top