FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Lol ok I was tryin to figure out trim up I thought would be middle and top but that’s trailer.
now it’s working again when I push middle and top so not sure what’s dirty but it’s getting better or something idk
Ok I found a wire without a fuse in it the red wire from bottom jumps up to the middle button
I hooked those together and it worked when I push top and middle. Nothing just pushing top
Now. I tried again and it didn’t work. Then it did. Now I hear it click? Back by motor when I push...
Ok I think I found the problem but not sure.
the blue wire has a split but it goes to nothin
I found a purple w white stripe that has the same kind of connector but goes to nothing.
mic I look at the ends of them the wire coating is brittle and comes off are these spose to be hooked together...
I have to be missing power at the middle button coz I’m not sure using the middle button matters as far as making it go down ya know?
gonna see if I can get under dash to grab some testing on the switch buttons now
Ok I’m on it 👍🏻
I know there’s 2 loose wires from the trim senders on outdrive. And another two loose
Wires with a bullet connector and a ring connector. I never really worried about making the trim tabs work right coz I never trim it while boating. If it’s a have to to make the drive go up...
Also the black wire on B one is a short wire that screws to the motor housing the other goes to the neg on battery. Not sure how it’s a ground issue. Unless I confused myself don’t it mean the sol is bad if u run power to C and it works? Or is that mean ground is bad? I never took the end of...
