The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
Lol ok I was tryin to figure out trim up I thought would be middle and top but that’s trailer.
now it’s working again when I push middle and top so not sure what’s dirty but it’s getting better or something idk
Ok I found a wire without a fuse in it the red wire from bottom jumps up to the middle button
I hooked those together and it worked when I push top and middle. Nothing just pushing top
Now. I tried again and it didn’t work. Then it did. Now I hear it click? Back by motor when I push...
Ok I think I found the problem but not sure.
the blue wire has a split but it goes to nothin
I found a purple w white stripe that has the same kind of connector but goes to nothing.
mic I look at the ends of them the wire coating is brittle and comes off are these spose to be hooked together...
I have to be missing power at the middle button coz I’m not sure using the middle button matters as far as making it go down ya know?
gonna see if I can get under dash to grab some testing on the switch buttons now
Ok I’m on it 👍🏻
I know there’s 2 loose wires from the trim senders on outdrive. And another two loose
Wires with a bullet connector and a ring connector. I never really worried about making the trim tabs work right coz I never trim it while boating. If it’s a have to to make the drive go up...
Also the black wire on B one is a short wire that screws to the motor housing the other goes to the neg on battery. Not sure how it’s a ground issue. Unless I confused myself don’t it mean the sol is bad if u run power to C and it works? Or is that mean ground is bad? I never took the end of...
update. If I jump Aand C motor runs
If I run a 12v from battery to C it runs
The 40 amp inline I tested using the beep when I touch a lead to each side so that’s good too
I’m in process of changing that ground wire on top of motor housing to the flywheel housing
Dropped a nut and it...
Yea yea that’s the one I was lookin for. All the wires are correct im going to put a new ground from Motor to engine housing to replace that corroded bare one that’s twisted together
That black wire goes to neg on battery. There’s a wire goin from engine to top of motor but it’s old looks like po twisted it together I didn’t replace
That one coz the one on sop goes to battery should I go ahead and run a new ground wire from the top of motor to the flywheel housing?
yiud...
See the blue wire goes to big post if I jump two big posts it should go up right?
what do I test to see if maybe that 40a in-line is bad on the small red wire??