I need a good way of purging/refilling my power trim and titl system. I has to repace the motor and made the mistake of manually lowering the engine with the motor off and most of the fluid spilled out. It is a 1989 mercury 100HP. from what i can tell it is some sort of cross between and 3 ram...
I have a 1989 Mercury 100HP outboard with Power trim and Tilt. Used the trim and tilt a week ago and it worked fine. Tried to use it this weekend and the it would trim up or down. I hit the button on my throttle (the only button to operate it) and all i hear is the solenoid clicking. Is it...
Hi Everyone,
Ive got a 100HP Mercury outboard 4cylinder. It is the model that has the trolling feature built in. At low idle, only (2) of the cylinders get gas. When the engine goes above 1800RPM, than the remaining two cylinders kick in. The issue with the enigne occurs when i try to accelerate...
I have a 1989 Merc 100 hp 4 cyl. It runs great most of the time except when i try to take off fast out of the hole. when im going slow than try to ounch it (like if i were pulling a skier) it bogs down for a second than accelerates like normal. It does idle a little rough. I have pulled the...
I have a 100HP 1989 Merc Outboard. It has the trolling feature which shuts down two cylinders below 1800rpm. My problem is that it bogs down when i try to accelarate real quick (when pulling skiers). It idles failry rough as well but runs perfect at full speed. Any ideas
I have a 89 Mecury 100hp outboard on a sea ray boat. The engine has a trolling feature which disables the two lower cylinders when the engine is at low RPM's. The problem is when i start the Engine cold, and let it idle for a bit, the two lower cylinders flood and i have to pull the plugs and...
