Recent content by pn

  1. pn

    1989 GT150 VRO2 conversion to Gas

    Re: 1989 GT150 VRO2 conversion to Gas do a search on removing vro, you can run two pumps and toss your vro. if you haven't gone through your carbs i'd do that too.
  2. pn

    VRO to twin pumps

    Re: VRO to twin pumps i bought multiple pumps from different sources, used whatever came with the pumps, just like your pulse line off your motor right now, still good. Note: use the pulse line for pulse, fuel line for fuel inspect the pulse line inside before cutting. . a little embarrased...
  3. pn

    1980 Johnson 150 bogging down under load

    Re: 1980 Johnson 150 bogging down under load you shouldn't have to pump the primer bulb to get fuel pressure, pressure should be somewhere between 2-5psi, idle wot. double pumps?
  4. pn

    How can a 150 evinrude not on the VRO

    Re: How can a 150 evinrude not on the VRO well to see if its the carbs or the pump, test the engine after you do one or the other and see if the problem goes away...what is the problem anyways...or is this a preemtive strike on the vro.
  5. pn

    Coincidence?

    Re: Coincidence? maybe its just shaft play and everythin's fine. the impellar will squeek when turnin dry or the stupid knockoff don't fit right and got burned up. heres a pic of my knockoff impellar cup notice hows it rounded out....
  6. pn

    85 v4 140 hp vro fuel pump pressure drops to1 psi every 3-4 seconds- need replaced?

    Re: 85 v4 140 hp vro fuel pump pressure drops to1 psi every 3-4 seconds- need replace double up your pumps the drop in pressure is odd. engine misfire or bad diaphram.
  7. pn

    Please Please HELP HELP HELP!!!!!! 1995 Evinrude 115 HP Outboard

    Re: Please Please HELP HELP HELP!!!!!! 1995 Evinrude 115 HP Outboard double up your pumps.
  8. pn

    pictures of ovaled sierra impellar cup 120 v4 looper

    So to be safe... i decided to change out my new to me 94 120tlend v4 looper impellar with a new water pump kit Sierra part 18-3390 w/o housing. low psi 4 and then... no pee stream, taking it apart i noticed that the stainless cup hole was not lined up with the shaft and ovaled out, also the...
  9. pn

    top speed on a 15 aluminum pushed by 5hp 4 stroke???

    i have a 5 hp. thinking about getting a 15' aluminum v bottom trying to figure out how fast i can go on flat water, i'm thinking 10mph. anyone know w/ two people? thanks in advance.
  10. pn

    Can anyone tell me what this line or hose is for tohatsu 9.9

    i've got this new to me 9 . 9 and i'm going thru her but i can't figure out what this line does. on the diagram it says lubricating line, now if i run it with the line disconnected it feels like crankcase plusating pressure, no fuel coming out just air. if i blow air into the brass nipple on...
  11. pn

    Is my drive shaft jumpin up and down? 72 35 hp water pump issue

    Changed water pump and then no water. Tearing apart and inspecting the impellar showed the top of it heated up against the housin. I think my drive shaft jumps up and down so upon changing out second new water pump i decided to put a piece of garden hose on top of my spline shaft on the...
  12. pn

    V4 1992 thermostat question

    i just recieved two new bullet thermostats off line and checked them in hot water with ir gun. part no. 434137 this is what i found. The one stamped O2BX opens at 145 The one stamped H1C opens at 155 I'm not too worried but should i be?
  13. pn

    1992 V4 120 VRO conversion to dual pumps pics

    200 to rebuild a fuel pump is out of my range so i handed my dead vro pump to a boat mechanic who promptly replied he had 50 of them. correct me if i'm wrong but any of the small fuel pumps will work, new or old, amazing but they're all the same, 9-115 hp, same 15 dollar rebuild kit, sierra...
See more
Top