PatinIdaho's latest activity

I’ve never seen roller bars like that but it looks like they could be lowered, as long as they can pivot enough. I was able to get lower...

Got some more sanding done today. The absolute worst part of the job! But I am about 90% done and should be done in just a couple more...

so you are not of this country given your usage of the metric system so not sure but here in the states about 1979 i think foam of some...

Our trailers are constructed very similarly. I measured today at my chine to finder and after lowering it 1-1/2 inches earlier this...

Why would i need all 6 holes? When im talking about dropping 1 more hole is available. I don't know if it will want to twist the main...

Thinned epoxy is a fools errand You can't unrot a boat. If water is in the stringers, it's in the flotation foam

My boat sits too high on the trailer. I have already lowered it 1-1/2 using the provided holes for the crossbar. It has helped a little...

After 3 days of rain, today was dry and a high temp of 45. Got the boat off the trailer more or less. There is a slight amount of weight...

Gee, I have done fiberglass work in the dead of winter here in the NE. I put some blankets over the hull and an electric heater inside...

Hmm. In the back of my mind i had the idea that i could get a sheet of foam insulation. Cut it to fit the outside of the transom. Get...

take dimensions pull windshield replace carpet rough-fit windshield, using a straight pic or awl to locate screw holes reinstall screws

Yeah, poly resin is plenty strong, especially vinylester.

I have about 1000 more pics than I have posted, both before and after.

I just got a 6-foot level yesterday. Before i fiberglass anything, the hull will be flat. From what i read, epoxy is the best to use and...

Yeah. I measured everything from deck height down and from center out before anything was removed.