http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=110401544812&_trksid=p2759.l1259
Okay... I have an older 1990 202 CC and I'd like to like to refresh a little and found this on Ebay. Why not start a new project???? My thoughts are....
The hull is bare (no nothing)
No trailer
I'd...
Hi gang... Never had any trouble with this motor and today it stopped peeing and got hot with minutes. It sounded as if it was hissing/blowing out air from the pee hole. I blew thru all tubes - no blockage. I pulled the lower end and inspected the pump and blew thru the lower unit tube...
I am trying to cut some corners (time & money) and wondering WHY I should NOT use heater hose as a rub rail insert. I already have the rail...
I can get this for about $.99 a foot X 45' and buy it from the local auto-mart. The other from Taco Metals $125 with shipping.:confused:
So..... WHY...
Here we go?. Project #2. Our boat came with a maroon bimini top and I could not stand the set-up and clearance, while my wife had issue with the color?. SO, I am making a T-Top (TT) for my boat. I have read the naysayers comments and agree with them for the most part, BUT being a DIY?r I...
Hey Gang... Take a look (no laughin') at the pics that I added stripes to my boat... UP-HIGH or DOWN-LOW??? Maybe you have a better design???
(I had to draw in the rubrail since its not on the boat and 100% black)
Tell me what you think??? THANKS!
-OP-
I know I am doing a lot of asking & not much giving, - I need all the help I can get & hope to pay it forward soon!!!
I applied the I?lux Pre-Kote with both a closed-cell 4? roller and ?? nap roller 9??. The ? nap offered great coverage, but maybe too good so I switched to the 4? roller after...
Okay... so this site has got my geeked-out and ready to add a little color above the water line on our boat.
I am using Interlux's pre-coat primer & then brightside for the finish... I sanded the hull with 120 and knocked down the chalk, removed all decals and stripes, and filled all voids...
My local auto shops do not have this and I'd like to buy it on a single roll.
I have searched the web & forum and just thought I ask again if any new places are out there to buy this?? (even ebay let me down):confused:
Thank you!!
Hi Gang.... to get my livewell to fit under the leaning post I had to trim a corner half an inch and now a bit of the foam core is exposed... What ideas are out there to seal the open area to prevent UV and water damadge? (cooler is white)
Thank you!!
I am trying to locate a supplier to purchase replacement gunnel inserts for 1990 Sportcraft CC. They dont appear to be a factory option... They are on both sides and are plastic trays that hold / store 2 rods each side. The rods are then hidden in the gunnel when used. I think the cutouts in...
Okay?.. if two heads are better than one - I need some advice on this before I get too far in the wrong direction. This is my 1st boat and when i bought the boat it had a soft spot in the floor and it was raining and I didn?t think too much of it? The previous owner had a cooler for a seat...
Hi Gang.... Great site!!! I am enjoying this forum and its time to ask for some help.... I am getting started on my project; Fishmaster 202 CC... We love the boat - but its U-G-L-Y!!! For the sake of this post its about Interlux or other paints. I had a vision of sky-blue above the water...