Thank you for the reply. I will look for it this Friday. I am getting a large amount of water when I pull the plug but have never heard the bilge turn on. I want to make sure it is working.
I have been noticing that I have been draining a large amount of water when I take out the plug. I am not sure if my bilge is working and want to replace it. There is a through hull connecter at the bottom of the boat. Question 1 where is the bilge located and how do I get to it. Question 2...
So I think it was a combination of color wiring and the inline fuse. I ended up getting the trusty DVOM out and looking for continuity and figured out that the color codes did not match up. Thank you for all of your help. I have tilt back but did not turn it over as I was out of water...
Still working through the issue. I did find one of those resetting fuse switches that kept clicking. There are three with two being positive and one being negative. They are labeled bat 1 and bat 2 on the red but both come out of bat one. I am wondering if there is not a short in the red bat...
Where are the fuses for the trim? Are they inline somewhere? I should state that all accessories as well as the pumps work. FM and VHF radio work but tend to work off of the deep cycle battery and not the starter. The main switch works fine.
I just pulled my boat out of the winter and wanted to change the lower end oil. I tried to tilt the engine and found I have no tilt. So then I attempted to just see if the engine would turn over and it does not turn over. I am convinced I have an electrical issue and the battery tests good...
I believe it is working. I see no evidence of bypass and I can say that the gas in the tank had no oil added to it since I had to replace the sending unit. I have already taken the boat out so the water pump works. When I took the spark plugs out and saw some oil I figured this is most likely...
I just recently purchased this engine that was on an astroglass boat. I am currently going through the engine and noticed oil in on the plugs. I asked the previous owner what kind of oil he was using and he stated he was using 4 cycle oil. I believe this is a 2 cycle engine. Am I correct...