I am looking at a boat that has no engine
it had a omc king cobra ford 460 and drive
what I want know is can I put in a smaller ford engine like the 351
is it and be bolt in or can I use some other engine
also what drive will bolt up.
jim
I have a older 10 or 15 hp merc outboard
its silver with green hood
if hood is off you cant start motor
my research its some were between
1949 and 1953
it does have a tag just have to check
jim
did carver ever make a 27' boat with around 8 ' beam
I am talking to a person with a 1987 carver 27'
with twin 180 's that he says have 8 ' beam
if its 10 ' I want to stay away from it
for I want to tow it
seams to me that there is now
adds on cl that is fake
they just not sound right
to me.
one add on Pittsburgh cl
says free boat but boat
is in police impound lot
buyer to pay half of impound fee
have to pay $175 to get it
out and owner pay $175.
I am getting a 1988 subird boat this weekend
used to have omc cobra but only thing there is gimbal
and interplate
will a 140 merc bolt up to inter plate
and matching drive bolt to gimbal
or do I need to replace everything
can't seam to find a cobra
I maybe getting a boat that came from Canada
it is a cutter boat model 215
s.n. 73031
beam 94"
numbers on it reads 35e9910
can anyone know were I can find
out if its stolen or any info on
this boat
I think my lower unit seals are bad
I drained the oil and got 8 oz. of oil
I was test run motor and oil driped
out of lower unit
not sure from lower unit or
out of exhaust port
jim
1987 Yamaha 15 elh
removed top gear shift pin
to remove lower unit
now I can't get pin in
one side is open ( left when face back of motor ) but
other side ( right side ) I can't even see hole
anyone ever had that pin out
I have a inboard prop shaft I am wanting to sell
not know if its worth anything
made out of bronze
just under 40" , 1" dia
one end tapered w/key & threads
other straight w/ key
I have a merc outboard s.n. 06486332 that turns over fine but no spark
like to know were the neutral sw. is located
is it on motor near linkage or on controls