FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Since I'm fixing all my other recent problems with my boat I might as well fix one I've had for years.
93 Bayliner, 3.0L, Alpha 1 Gen 2.
Ever since I've owned the boat, about 6 years now, it has always hesitated when accelerating. I've never been able to go from a crawl to wot. So if I'm going...
When taking apart my alpha 1 gen 2 I noticed the speedo tubing broken at the quick connect fitting. I'm in Alaska and it takes a while to get parts. Is it ok to run the boat without that hooked up? I was worried about water getting into the hole so I was thinking about plugging it at the drive...
Advice on my outdrive replacment
Advice on my outdrive replacment
1993 Bayliner 3.0 Alpha 1 Gen 2
Took the cap off the outdrive and the upper gears are completely shot, I'm assuming because I let it go low on fluid. So a few questions before I order the new upper.
When I drained the fluid...
17 Foot bayliner with 3.0 mercruiser and alpha 1
Ok...Fly wheel went bad, pulled motor and fixed. Had a hell of a time getting the drive back in. Take it out for the first time yesterday and everything was great for a couple hours. Driving along at almost full throttle and the I can hear...
So...
I'm removing my engine to replace my flywheel. My question is, is there anything else I should do while the engine is out? Seals or something?
And, this is my first time pulling a boat engine. I have all the wires and hoses disconnected and the front and two rear engine bolts out, is...
1993 Bayliner 1750
3.0L I/O
Long story short...
No spark at beginning of summer.
After lots of cranking find out safety teather is faulty-Fix and boat starts.
However, all the trouble shooting I did I got spark plug wires backwards-Lots of trouble shooting and cranking until I finally figured...
This is my girlfriends Polaris SL 750 that I've never rode before. I put in a new battery first thing this year. It apparently never had an issue until this summer. When trying to start the starter just spins like it's not engaging. I figured it was the starter so I took it out, which was a lot...
Took it out for the second time this past weekend and had a few question's. <br /><br />1. Even when warm I would have to rev engine in 'throttle only position' sometime's to start it. It ran fine at full throttle but would die when going from slowest speed to full throttle. I would have to...
Took it out for the second time this past weekend and had a few question's. <br /><br />1. Even when warm I would have to rev engine in 'throttle only position' sometime's to start it. It ran fine at full throttle but would die when going from slowest speed to full throttle. I would have to...
Trying to change the gear oil on my new 94 mercruiser 3.0. I think I understand how it's suppose to be done but I can't squeeze anymore gear lube in the fill/drain hole. More come's out then goes in. So I filled the rest through the dip stick hole until it came out of the vent hole. Let it sit...
