So I've been running my sportwin in a bucket after replacing the impeller. I was tuning the lean/rich needle trying to keep the smoke down and keep the plugs from looking too nasty. I had it sneezing then backed off about a half turn or so from there.
It starts up fine now. First try mostly...
So I'm at a point where I don't know what to do next.
I'm hoping someone can tell me some reasons why my motor could be having trouble turning over. Both the electric starter and me both have major trouble getting the flywheel to rotate when trying to start.
Plugs out and it's fine. Almost as...
I picked up the motor yesterday in running condition. The rich/lean adjuster is siezed up in what I think is the more lean adjustment and I went to see what the impeller was looking like and wouldn't you know it, two bolts sheared off below the surface. The flange about 5 inches below the bolts...
Well I managed to get the LU off. Not excited to try and get it back together.
The impeller seems to be I'm pretty good shape. Not cracks or brittleness, a couple creases on fins but nothing deep or about to break off.
Is the impeller supposed to be pretty tight in there? It seems pretty tough...
So I've got both of the coils out of the motor and I'm trying to figure out if they are both functioning. They were definitely replaced not that long ago and are pretty clean. I took the plugs out to check for spark while pull starting I had one plug have what seemed to be a weak spark and the...