hello,i think I may have a injector that's not working.can anyone please tell me the best way to check or to test them without havin to disassemble the the carbs?
the engine runs good but it souds a little weak .and while runnin on lower lower speed I can hear a shurging as if a cylinder is...
lookin at the bushing that goes around the shift shaft ,and the seal looks like its upside down.doesnt the spring side go towards the oil ?and also can anybody tell me how much gear oil goes back in it?
thanks.
hello ,iv been working on this engine on and off for a while now and finally come to the conclusion that the ecu is bad .its not firing on one of the injecter wires .any way can anybody tell me if these ecus are repairable or do i have to cough up 1200 smakers for a new one?
thank you.
has anyone or can anyone tell me if there is a way to test the output on a ecu going to the injectors .i know that it gets a signal from the unit but is it to quick to check with meter?im begining to suspect it droping signal .any advice on this subject would be great!!
can anyone tell me if these res measurments are correct?
ground to red/white .031
'' red .031
'' blue/white 2.104
'' blue 2.030
dig.meter set for kohm.dont have dva can only do this.
also on trigger i was doing res. test and...
