FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I am having a hard time determining where my water intake is on this engine which runs beautifully. Below the prop facing the rear is an opening with a screen pointing down and on the side above the prop is a small rectangular plate that has a screw. muffs really wouldn't fit on any of them...
I have the above motor and noticed that the "throttle arm?" that controls speed is a bit tight and gives you a good work out after a day of crabbing wit the starts and stops. I greased the teeth at the back of the arm and it didn't seem to loosen it up at all. I was wondering if there is a way...
Hi All,
I'm new here and just purchased a 14-6 aluminum Grumman with the engine noted above. Cant wait to go crabbing/fishing. One question...I don't think you can do it, but can the engine be tilted up in order to get the prop high when pulling the boat out or launching from a ramp? I can't...
