Recent content by DanNeedsHelpWithBoat

  1. D

    1971 Johnson 50HP hydro shift problems with reverse running smoothly.

    So I swapped out my lower unit recently. The new lower unit works great in Forward gear but is a little clunky in reverse. If i shift into it at low rpm sometimes it wants to die and there is a sweet spot with the throttle. if I got beyond the sweet spot it revs a ton but the power to prop cuts...
  2. D

    1972 Johnson 50HP electric shift problem

    Hi, So I had just rebuilt the transom on my 1952 fiberglass runabout, i loaded the boat up with some friends and hit the river for a little sunset cruise. The engine started up great, we had gone about 6 miles up the river then there was a loud sound from the engine and we lost power. The motor...
  3. D

    Seized lower unit rod/bolt on Evinrude 40HP Lark 7 electric shift

    Hey, anyone have any advice on getting out one of the vertical bolts that run through the lower unit? The manual says they will seize and you need to cut through them, which I did on the one that is seized. I figured I could just weld over the cut in the aluminum housing. Ive tried Sea Foam Deep...
  4. D

    1965 Evinrude Lark 7 Electric Shift lower unit repair

    So I have the entire boat rewired starting right up on first ignition key turn! but now there is water getting into the lower unit and oil leaking out of the lower unit. I ordered a new seal kit for it that hasn't showed up yet, but Im just wondering if there are any seals that tend to go sooner...
  5. D

    A few questions about 1965 Evinrude Lark 7

    Hi, My brother and I bought a junky 14ft fiberglass Seaswirl that we are trying to get up and running. It came with a 1965 Evinrude Lark 7 and I have three questions. 1. What is the proper oil/fuel mixture for this engine. 2. It is best to use marine leaded gas with these older engines right...
Top