A few questions about 1965 Evinrude Lark 7

DanNeedsHelpWithBoat

Cadet
Thread starter
Joined
Mar 29, 2016
Messages
20
Hi,
My brother and I bought a junky 14ft fiberglass Seaswirl that we are trying to get up and running. It came with a 1965 Evinrude Lark 7 and I have three questions.

1. What is the proper oil/fuel mixture for this engine.
2. It is best to use marine leaded gas with these older engines right?
3. This is the 'electric shift' model but it seems like the shifting controls are basic teleflex with a shift lever, I'm not sure that the "forward/nuetral/reverse" buttons work at all. That being said do I need to put in Type C gear oil in the lower unit or would standard Marine 90w work?

thanks,
Dan
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
Welcome to iboats

1. 50:1 TCW-3 oil
2. They seem to run fine on todays unleaded
3. The electric shift motors use a single lever control, Evinrude controls had push buttons for shifting.

Type C oil, now called Premium Blend by BRP is required if you have the electric shift

The non electric shift engines have a gear shift lever on the starboard side of the engine, the electric shift motors do not. Could you provide a model number please. It is located on the transom bracket between the clamps
 

DanNeedsHelpWithBoat

Cadet
Thread starter
Joined
Mar 29, 2016
Messages
20
Here is a pic of the engine and the shifter if that helps
 

Attachments

  • evinrude_motor_1.jpg
    evinrude_motor_1.jpg
    309.1 KB · Views: 0
  • evinrude_shifter.jpg
    evinrude_shifter.jpg
    248.8 KB · Views: 0

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
Well the model # checks out as an Electric Shift

The control you show is for an electric shift.
The picture of the engine is the port side showing the throttle cable
It is an Electric Shift, if it weren't, the port side of the engine lower engine cowl would look different, as would the anti-ventilation plate visible in the lower right of the pic
 
Last edited:
Top