I am updating my sound system and curious about what gauge wire should I use for running the yellow and black wires back to the battery? Its a 8-10 ft run... I was thinking of using 12 gauge. The red will be connected to a separate on/ off switch, so im not worried about that.
So I just recently removed all my brackets for my current swim platform setup and have 16 1/4 holes, I've already drilled them up to 3/8 for fresh material, what would be the best way to fill these holes? I have west systems epoxy and 404 filler from a past project... what I'm thinking is to...
Are these bunk brackets reliable??? This is my first lift I am buying for my boat and it just doesn't seem like they will hold the boat up... I also need to cut those poles down so they dont dig into the sand... they a little to long.
My transom cut out... what do you think?
I have a 89 Powerplay Integra and I am swapping my transom assembly with a new one. I also just recently re-painted the whole bilge. So I sanded down the cut out and would like to seal it up and strengthen it more. What resin would you use for this? How...
I have a 89 Powerplay Integra and I am swapping my transom assembly with a new one. I also just recently re-painted the whole bilge. So I sanded down the cut out and would like to seal it up and strengthen it more. What resin would you use for this? How does the condition of the wood look to...
I just picked up a much nicer condition alpha transom assembly and while taking off the main oring seal, I took off some paint on the edge of the inner part from an adhesive remover... the guy used 4200 under the seal and it wasn't coming off easily, so I ended up using a plastic scraper and...
I just bought a nice used alpha transom assembly for my boat and the guy used 4200 in the groove where the big rubber seal goes. Any ideas how to remove the 4200 from the groove? Its impossible to get a razor blade in there...
It was never installed so I guess I dont HAVE to remove it but...
There was a block in the middle of the bilge so that the bilge pump could be screwed into to secure it. Well found out last season that it was rotted and decided to remove this year.
Well its removed and sanded down, the glass/epoxy looks good and dry. Just looking for some direction on to...
Im going to be putting back together my windshield and when it comes down to the rivets... can I use the aluminum head and the steel mandrel or do I need to use all aluminum rivets?
So Im going to replacing the axle and leaf springs this weekend and to honestly Im a little nervous about working under the boat like this. I have 2 jack stands, 2 4x4s and a 5k jack. Im not sure what will be the best way of lifting the trailer off the ground with the boat on it. Can anyone...
I have to replace my axle... so by looking at the leaf springs... should I replace them also? They aren't sagging like my old jeep Cherokee was and looks like they have a little surface rust on the bottom of them. Opinions would be wonderful.
Im replacing my old bucket seats with some bolsters... just quite not sure on what color scheme to go with...
Im pretty sure the charcoal seat will match the charcoal carpet, but not sure about the upholstery I have... Thats why im kinda thinking all white...
Re: How Fast Does Your Boat Go?
In the video at the end I was hitting 68, but the rest of the video I was cruiseing at a nice 46 at 3500rpm. But yes thats my boat. Been doing a total restore on her.
Just curious... When I got the motor back from the builder he had one breather hose going to the flame arrestor and the other to the carb... I changed it so that both go to the carb. Was this a bad move? Should I switch it back? The motor is a mild build 400 sbc...
