Is the Speedo not working usually caused by a clogged Pitot tube?
Can I just disconnect the tube from the back of the speedo and blow on it?
Where does the other end connect to?
We took a trip to Boulder City last month and drove by Lake Mead (for the first time) and loved the layout.
So we're planning a trip there late August.
Well my old leaf springs and hardware was so rusty it was starting to scare me. So I bit the bullet and had them install a complete new set. The existing setup I had on apparently they no longer make, so they had to install a completely new system.
Now they tell me that this center pivot...
Not sure why, but my boat leans towards the starboard side even with no one inside. This makes it difficult to put on the trailer evenly. I was thinking of putting a couple of 50lb sand bags on the port side to even it out, but was wondering if there was something else I can do to make sure it...
I want to pick up a set of new Anodes for my Mercruiser Alpha One, and I want to make sure they are proper for Saltwater.
Are these the correct ones?
http://www.boatzincs.com/alpha-one-gen2-kit.html
Anyone have any opinions they can share in regards to Silverwood Lake in Hesperia?
Thinking of going there for a couple of days for camping and boating.
I just noticed the entire section of the underside of my Trailer Lights is exposed. Wouldn't boat Trailer Lights normally be waterproof? Or is that considered an upgrade?
Would this be the correct Service Manual I should get for my engine?<br /><br />Upper Unit 4110164303; Lower Unit 4112041235<br /><br /> http://www.iboats.com/mall/index.cgi?keywords=volvo%20penta%20manuals&*******=373642658&**********=084023856&view_id=214921
This is pretty close to what my bow roller looks like on my trailer, but it doesn't actually roll and when I winch up the boat, it rubs pretty good.<br /><br />Should these rollers actually roll or are they made to be stationary?<br /><br /> http://www4.shopping.com/xPF-Stoltz_Ultimate_Bow_Stop_4