Recent content by 995jim

  1. 9

    trailer spindle nut

    Hello, If I set my heel bearings and back the spindle castle nut to the closest cotter hole but still have a very slight play when I try to wiggle the tire side to side Im assuming I should go ahead and snug the nut to the next cotter hole to eliminate said play. Is the elimination of play more...
  2. 9

    prop nut tightening

    Hi, is using a 2x4 wood block as a jam work to torque the prop nut or is this a big no no?
  3. 9

    bravo 1 outdrive o-ring adhesive

    ok, thanks for clarification, I was just interpreting the manual to apply to both sides which I thought would be strange.
  4. 9

    bravo 1 outdrive o-ring adhesive

    my mercruiser stern drive service manual #11 only notes the shift cable and water passage o rings to be coated with 3m sealant, Im assuming the o ring that serves the remote gear oil reservoir probe would also need sealant. When I removed the drive the o ring that seals said gear oil probe didnt...
  5. 9

    bravo 1 outdrive o-ring adhesive

    Hi, is contact cement or adhesive what I want to use when replacing the o ring seals at shift, remote oil, and exhaust connections on the outdrive for re assembly. Not sure if there is a difference between 3m adhesive and a jar of dap contact cement other than the name. I have 3m spray 90 but...
  6. 9

    outdrive primer paint

    hello, I have some 2 part epoxy primer for automotive and wonder if this is acceptable to use on my bravo outdrive . thanks jim
  7. 9

    bravo1 gear oil drain plug

    thanks. picked up 2 and installed, just took some time to clear out the old fiber (cardboard) ones of course
  8. 9

    bravo1 outdrive trim tab

    Hello again, What is the purpose of the trim tab just above and trailing the prop on the bravo drive. It bolts through the fin just above the prop. Unpainted thanks jim
  9. 9

    bravo1 gear oil drain plug

    hello, Ive drained my lower unit gear oil on my bravo 1 outdrive and am wondering if I should replace the washers that seal the drain and vent plugs while oil is drained. Not sure if its a good practice or if its not broke dont fix it scenario. thanks jim
  10. 9

    which order to do maintenance

    yes, I was confused with terminology sorry my bad as I was referring to the drive shaft u joint. thanks
  11. 9

    which order to do maintenance

    isnt the u joint in the outdrive called the gimble? I assume you have to pull it apart to grease. 1990 vintage
  12. 9

    which order to do maintenance

    Hi, Its time to pull the bravo1 lower unit and grease the gimble joint and also do a lower unit oil change. any advise on which to do first? Also can i just drain the oil once the lower unit is pulled away from the stern and refill after bolted back up? thanks jim
  13. 9

    spindle/ hub seal tolerance

    Hello, what is the tolerance or overlap in thousandths of the seal to the spindle diameter? thanks jim
  14. 9

    oil filter part number

    Hi, Does anyone have a oil filter number for a mercruiser 454 mag 1990 vintage thanks jim
  15. 9

    hub dust cap

    what I noticed was that the new bearing caps i installed were stamped with a good tolerance to lock them in but once I removed them the diameter was compressed causing a lack of tight fit when wanting to replace. Im thinking the caps are a cheap, thin chinese POS.
See more
Top