Search results

  1. holorinhal

    Evinrude suposed 40hp year identification.

    Can any one identify, the year model of this Evinrude outboard? Is said to be a 40 hp. There are no tags any where, i have found no serial numbers. It is a single carb, two cylinder power head. Any help would be appreciated.
  2. holorinhal

    Water in oil, milkshake.

    Ok so, back in march we were at the river. Boat ran great all day long. Got back to beach and hung out for a few hours and when we went to start up to pit on the trailer, engine wouldn't bump over. Just clunk, clunk, like starter went bad. So i have asumed that bad starter. Ordered new starter...
  3. holorinhal

    81 260 5.7 mercruiser dipstick

    Any one know off hand the length of a 81 year modle 260 mercruiser 5.7? i put 6 quarts in, one in the filter and 5 in the pan and it does not register on dipstick. not sure if it is the original or not. dipstick goes through tbe block not the pan.
  4. holorinhal

    Mercruiser 260/alpha, seems to be running hot.

    81 mercruiser 260/alpha, with EMI thunder exhaust, SS risers. 160* thermostat. So the temp gauge reads from 160-175 ish when running at speed, then creeps up to around 210, when i come down to an idle or flat wake. A couple weeks ago, i had two sections of exhaust water boot, melt and get holes...
  5. holorinhal

    Mercruiser MC-1, Alpha1 shift interupt

    I have a couple questions about the shift interrupt system and shifter controls. ​I have an '81, MC-1 drive 260 Mercruiser. I am having trouble with shifting from forward and reverse, into neutral. When shifting, the controls or cables feel like they are binding. It is very hard to go from...
  6. holorinhal

    Thermostat housing, Tstat and gaskets, i have questions.

    i have a 1981 Merc 260( 5.7l 350cid) with a MC1 or Alpha drive. I upgraded fron the old cast iorn log exhaust to EMI Thunder center rise exhaust. i aslso changed the thermostat housing to a Sierra #18-3530-1. i originally hooked every thing up , without a tstat to get the engine fired up, but...
  7. holorinhal

    No pee thru the tell tale

    I have a 1988 Merc 100 hp. I recently got it fired up, after sitting for quite a while. When it was running, on the muffs, there was no water comming from the tell tale, but the is from the hub. I droped thelower unit to change the waterpump and the impelor was still in tact with no broken...
  8. holorinhal

    Mercruiser 7.4 center rise exhaust spacing

    Any one know or know where to find, how far appart centerline of the exhaust risers are, fron centerline of the crankshaft, on a 7.4(BBC) Merc are? I have searched forever and cant find the info. I have once had a diagram with dimentions, bu can not find it. I am installing thru hull exhaust, on...
  9. holorinhal

    88 Mercury 100 hp fuel/carb questions.

    I have a 1988 oil injected 100 hp merc. It had been sitting for about 15-18 years, since my dad took the motor off the boat, because he thought it had a oil problem, due to a constant beeping oiling alarm. I have since figured out that it was a problem in the oil tank, with the float. I have got...
  10. holorinhal

    1988 100 hp mercury, constant beeping at key on

    Ok so with the help of some good people on this forum, I got the year and model figured out and how to hook up 12v power. Now for the real problem. About 15- 20 years ago, hell I have lost track, My Dad pulled this motor off of his bass boat, because he thought that it had an oiling problem. He...
  11. holorinhal

    Mercury 100 hp oil injected modle year identification

    I have a 100 hp Mercury oil injected outboard motor. How do I go about finding out what year it is. I cannot seem to find any serial numbers. The controls have two wiring harnesses, one with a large pin connector and one with a small pin connector. I am missing the small pin cord and am...
  12. holorinhal

    Trim unit power leads

    I am rewiring the boat from the previous owner hack job. I am at the point of the trim unit. I have looked at the wiring diagram in the service manual and i do not see where it tells of the wire gauge size. I need to know what gauge are the red and black power leads, that go from the trim unit...
  13. holorinhal

    Commander 3000 Classic remote controler

    Does any one know where I can find a full manual for the commander 3000 Clasic throtle/shift controler. I have found the part with the asymbly and disasymbly of the handle and bezel, but would like the portion for the module behind the bezel, for cable replacement and wireing of the neutral...
  14. holorinhal

    How do I wire this switch?

    I have this switch for my nav lights. It is a cole boston 3 position 4 pole switch. the two poles, on thr side close together are labled H (front) P (rear), the pole nearest the front at center is labled B and the pole on the right side is labled R. The lghts that I have are a white light on the...
  15. holorinhal

    Is it necessary to run a thermostat in a '81 Merc 260

    I converted My '81 260 Mercruiser from the old log exhaust to EMI THUNDER center rise exhaust. I had to change the thermostat housing to a newer style, with less hose conections. Question is can I run without a thermostat or is it absolutley necessary? Below is a picture of the new exhaust and...
  16. holorinhal

    Gimble housing and Inner transom plate installation

    I have searched alot, for the information, thru the web and the manuals, but I cant seem to find the answers I am looking for. I have just finnished doing a face lift on My boat and am ready to reinstall the outer transom shield and inner transom plate and need to know if there are any...
  17. holorinhal

    1981 mercruiser 260, is it an original mercruiser block?

    I have an 81 21 ft Spectra day cruiser. The engine is a mercruiser 260/5.7 chevy. I pulled the engine to take care of a transom leak and replace the floor and while i have the engine out i becided to clean and paint and inspect every thing. The previous owner said that it was a frsh rebuild. I...
  18. holorinhal

    mercruiser power steering ram

    So I have done quite abit of searching and have looked at the manual and still do not get it.So the question is ,How to remove the power steering ram from the inside transom plate? I have removed the pivot bolts but seems like there is something else that needs to be done. Plate is on a 1981...
  19. holorinhal

    merc 888 outdrive to 260 outdrive.

    Would a merc 888 outdrive work in place of a 260 outdrive canthey be interchanged. I have a 1983 260 mercruiser with a 5.7/350 and my outdrive has a chiped tooth on the gearset. I can get two 888 outdrives for free that are in exelent shape,just wondering if they will interchange,and what are...
  20. holorinhal

    Stern drive engineerings se106 alpha one replacement

    I am looking at purchaseing a SE drive to replace My drive with a broken upper gearset tooth. I was noticing that the only gear ratio close to mine is a 147:1, I have 150 gears on a merc 260. will the 147 gears be the same? why would they not offer the 150 gear ratio...
Top