Won't trim down while on step

Javelin379T

Recruit
Thread starter
Joined
May 15, 2017
Messages
5
I have a 1995 Johnson Fast Strike 150 on a Javelin 379T. Took out this weekend and noticed while running, once the engine is level and I trim up to reach higher rpms/throw a rooster tail it won't trim back down when I need to come to a stop. Once I back down and get to an idle the motor then trims down. What do you think is causing this, low hydraulic fluid or maybe the trim motor is going bad?

Thanks in advance
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,330
I think your tilt mechanism is physically jamming, preventing the motor from trimming down. Check the rubber mounts for any play as well as any wear on the tilt tube to triple clamp or transom brackets.
 

Javelin379T

Recruit
Thread starter
Joined
May 15, 2017
Messages
5
Chris1956 There's no play in the rubber mounts and the seals look good. I'm thinking maybe the hydraulic rod itself may have a slight bend in it causing it to catch, or possibly an air pocket. I'll try bleeding and refilling...Thanks
 
Top