tilt and trim

smyrnatjc

Cadet
Thread starter
Joined
Mar 28, 2011
Messages
13
I have a 22 ft bay boat and the tilt (up) does not work from the bow switch or the switch on the throtle. Down works fine from either. However, the switch on the engine (Yamaha 0x66 200) works up and down. Any suggestions?
 

EricJRW

Chief Petty Officer
Joined
Feb 3, 2010
Messages
488
Re: tilt and trim

Time to break out the ohm meter and see where the connection is bad. Could be in the plug, or anywhere along the wires, or the switch itself. Since neither up or down works from the remote control, it could be the plug, the common, or the switch. Disconnecting at the plug and checking continuity from the remote control switch would be a logical place to start. If continuity does not check out at the plug, I would then check the switch. This will help determine if it's wiring or the switch. If that checks out, then it could be the contacts in the plug, or the wiring from the plug to the relays. In this case, looking at the common first would be the place to start.

This diagram may help: http://www.maxrules.com/graphics/omc/wiring/TnTwiring.gif

PS. When did it work last?
 
Last edited:

smyrnatjc

Cadet
Thread starter
Joined
Mar 28, 2011
Messages
13
Re: tilt and trim

It has been about a week. The boat sits on a lift here in Florida and we have had tropical storm Debby dumping water on us for days so I think it could be a short from the moisture. I will start chasing wires. Thanks and I will keep you posted.
 
Joined
Feb 17, 2012
Messages
2,906
Re: tilt and trim

if it was a short a fuse would pop and up would not work from any place. the up wire from the 2 remote switchs is broken or has a bad connection to the relays.
logic for this
3 switchs......1 works others work in down only....common 12+ must be good...relay is good....down wire is good
2 switchs fail at same time is slim.....boat builders are cheap and wouldnt run wire from bow to stern if they could tie in at throttle saving on wire so chances are bow switch is connected to throttle switch somewhere.....so i would start with wire from throttle to relay pack near motor and any connectors inbetween.
 

EricJRW

Chief Petty Officer
Joined
Feb 3, 2010
Messages
488
Re: tilt and trim

Good logic gpop. For some reason I thought neither up or down worked from the remotes. Yesterday was a bad day for reading for me. Tracing the up wire makes sense (now that I re-read the original post).

I particularly like the daisy-chained switch logic. If that's the case it narrows things down considerably.
 

smyrnatjc

Cadet
Thread starter
Joined
Mar 28, 2011
Messages
13
Re: tilt and trim

Thanks for the info. I found bad connections where the wires meet the harness even though they are shrink wrapped. Replacing all. Thanks agian
 
Top