Sticking trim and tilt.

[daveydoodle]

Just noticed on my 50hp evinrude the tilt sticks when going down untill you press the switch on the lever and stops it. I replaced what I remember as an up and down (actuator??) on a chrysler motor I had a few yrs ago. It wouldnt go down at all ,advised to replace both.Easiest OB fix I ever did. Does this on the Evinrude sound like the same?? Daveydoodle.

 

[boobie]

Re: Sticking trim and tilt.

Sounds like a bad switch or relay.

 

[daveydoodle]

Re: Sticking trim and tilt.

Is the switch or relay sound like what I desc. on the chrysler. There was two plug in on rear port side,one for up and one for down,simply pull out elec. connections and replace with new. Think they were about 25.00 a piece. Did this 5 yrs. ago, memory a little water logged since. Havent pulled off cowel to look yet..