Tim Frank
Vice Admiral
- Joined
- Jul 29, 2008
- Messages
- 5,346
I have a gas-fired tankless water heater which is due for its first regular flushing.
It is not very complicated, but involves circulating vinegar through the pipes for an hour, at the rate of 4 gallons per minute.
I do not have a pump close to that spec, and would need to buy one.
There is a max of 5' lift involved here, so 4 GPM at max 5' should not be a very demanding requirement. I could use a stand that would reduce the lift to ~1'
The question:
Anyone got any suggestions for a relatively inexpensive solution here?
I have a few motors kicking around that I could use as power....or even a drill.
It is not very complicated, but involves circulating vinegar through the pipes for an hour, at the rate of 4 gallons per minute.
I do not have a pump close to that spec, and would need to buy one.
There is a max of 5' lift involved here, so 4 GPM at max 5' should not be a very demanding requirement. I could use a stand that would reduce the lift to ~1'
The question:
Anyone got any suggestions for a relatively inexpensive solution here?
I have a few motors kicking around that I could use as power....or even a drill.