Shift shaft question

Ernest D Trujillo

Recruit
Thread starter
Joined
Mar 28, 2017
Messages
4
Is it possible for the shift shaft to fall out of adjustment? It feels like the clutch dog don't fully engaged. If so how can I readjust it?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
What is the model number / pony power of your belch fire special ?-----------Motors are not all the same !
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Disconnect the remote control cable and see if it shifts properly by hand.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Shift shaft does not go out of adjustment by itself.---------Was the lower unit off for maintenance ?----Was powerhead off ?-----Have you drained / looked at the gear oil ?
 

Ernest D Trujillo

Recruit
Thread starter
Joined
Mar 28, 2017
Messages
4
The gear oil was real dirty, no metal grinding pieces. I did take off the remote. It does shift into gear. The problem is when the motor has a load. It jumps out in reverse and drive gear.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
It normally does not jump out of reverse.---So something is wrong.--Does the shift cable have a lot of play when you push / pull on the motor end of it ?----And is this a problem that showed up suddenly on both forward and reverse ?--Was there water in this gear box at any time in the past ?
 

Ernest D Trujillo

Recruit
Thread starter
Joined
Mar 28, 2017
Messages
4
I got the boat at the end of last summer. It ran great about 3 time on the lake. The 4 time is when it started all of a sudden. The cable seem nice and Tite. To be honest I'm not sure water got into the gear box. My thought was to change the gears and clutch dog.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Fairly pricey to buy new parts.-------May need to look into shimming the new pinion gear too.
 
Top