jedwards353
Cadet
Thread starter- Joined
- Mar 31, 2016
- Messages
- 7
On 4/28/10 Faztbullet stated " 92-up v4/v6 crossflow/ loopers shift shaft height 22" 1/8.
http://forums.iboats.com/forum/engin...-compatability
I'm really hoping your correct as the boat I acquired (named in subject) has been slipping in forward. Making a thud as if it hit ground. I checked the height and it was close to 21.5. WAY OFF. I raised it to what the Johnson/Evinrude manual ( pdf download purchased online) recommended-21" 29/32 and it was much better but around 3500rpm started making the thud again. But still a major improvement. Question is.... Your recommendation of 22" 1/8... Is this the proper height in your opinion? And why is it different than the manual? But I hope it is correct because I'm goin to raise it a bit more on Sunday and hopefully it will fix my forward progress problem, reverse is fine by the way.
http://forums.iboats.com/forum/engin...-compatability
I'm really hoping your correct as the boat I acquired (named in subject) has been slipping in forward. Making a thud as if it hit ground. I checked the height and it was close to 21.5. WAY OFF. I raised it to what the Johnson/Evinrude manual ( pdf download purchased online) recommended-21" 29/32 and it was much better but around 3500rpm started making the thud again. But still a major improvement. Question is.... Your recommendation of 22" 1/8... Is this the proper height in your opinion? And why is it different than the manual? But I hope it is correct because I'm goin to raise it a bit more on Sunday and hopefully it will fix my forward progress problem, reverse is fine by the way.
Last edited: