I am having a frustrating problem replacing the fuel sending unit on the 73 Aztec.
I pretested the ohms on a new marine sending unit before I cut the length of the rod with the float (in specs) and also tested the ohm readings with the sender set loosly in the tank. (It measured 145 ohms half tank). When I fastened it to the tank with the screws the reading dropped to 40 ohms. This reading was without the wires hooked up to the sender. I pulled it back out to double check the readings and it was in spec as long as it wasn't fastened to the tank with the screws. Could this problem be not enough of a ground to the fuel tank?
Now the fun part.
I refastened the unit, hooked up the black to the -- and the pink to the S side. Turned key on and 10 seconds later the key was hot and the # 2 fuse blew out. SFE 14A.
My bilge pump stopped working after the fuse blew. After replacing the blown fuse I pulled each fuse out to double check if any other fuses had blown. All were ok but when I turned the key on to test the switch to the bilge pump, well it worked and the blower motor no longer works.
The + wire on the #2 fuse gets hot still. The wires to the sender at the tank are disconnected. I am guessing I have a dead short relating to the second problem. Then again the short must be in the flow to the fuel guage also.
Anyone have any idea what is going on here?
I pretested the ohms on a new marine sending unit before I cut the length of the rod with the float (in specs) and also tested the ohm readings with the sender set loosly in the tank. (It measured 145 ohms half tank). When I fastened it to the tank with the screws the reading dropped to 40 ohms. This reading was without the wires hooked up to the sender. I pulled it back out to double check the readings and it was in spec as long as it wasn't fastened to the tank with the screws. Could this problem be not enough of a ground to the fuel tank?
Now the fun part.
I refastened the unit, hooked up the black to the -- and the pink to the S side. Turned key on and 10 seconds later the key was hot and the # 2 fuse blew out. SFE 14A.
My bilge pump stopped working after the fuse blew. After replacing the blown fuse I pulled each fuse out to double check if any other fuses had blown. All were ok but when I turned the key on to test the switch to the bilge pump, well it worked and the blower motor no longer works.
The + wire on the #2 fuse gets hot still. The wires to the sender at the tank are disconnected. I am guessing I have a dead short relating to the second problem. Then again the short must be in the flow to the fuel guage also.
Anyone have any idea what is going on here?