Rule Bilge float question

Speakrdude

Ensign
Thread starter
Joined
Feb 25, 2004
Messages
942
I've tried two of these now with the same results.

In the front of the Bilge in this 88 Sea Ray 300 WE, there is a bigle pump with float switch.
The float is factory mounted with a slight downward tilt.

The problem is, When the water level comes up, the switch kicks on, no problem, but when its almost empty and the pump is surging, the float switch wont go down enough to shut off. I first thought I had a new (bad?) float switch. Rule, kindly sent me another, same problem. Do I need to raise, lower, switch, pump, ?/
 

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: Rule Bilge float question

Space it up some or angle it up instead of down.
Rule makes a clip that hooks into the slots of the bilge pump base that holds it up about a 1/2".


http://www.iboats.com/Rule-Super-Sw...2282695--**********.908502177--view_id.258950

29-65_0.jpg
 
Top