Vintageisking
Recruit
- Joined
- Nov 27, 2019
- Messages
- 3
Hello everyone,
While attempting to replace the floor in my 1984 Glassmaster I made the unfortunate mistake of cutting through the bottom of my hull (approx. 24”). I have done a bit of reading on hull repair and have a decent understanding of working with fiberglass. However this would be my first time doing so on a marine application. Any advice would be appreciated. considering the hull is almost half an inch thick, and since I don’t want to make a mountain out of a mole hill, I would like to bevel top and bottom accordingly and fill the gap in between with Marinetex before glassing both sides.
thanks in advance
1984 Glassmaster 15ft 115 hp merc
While attempting to replace the floor in my 1984 Glassmaster I made the unfortunate mistake of cutting through the bottom of my hull (approx. 24”). I have done a bit of reading on hull repair and have a decent understanding of working with fiberglass. However this would be my first time doing so on a marine application. Any advice would be appreciated. considering the hull is almost half an inch thick, and since I don’t want to make a mountain out of a mole hill, I would like to bevel top and bottom accordingly and fill the gap in between with Marinetex before glassing both sides.
thanks in advance
1984 Glassmaster 15ft 115 hp merc