Re: starter problem

merit131

Seaman
Thread starter
Joined
Sep 20, 2011
Messages
58
Re: starter problem

Re: starter problem

If you spend enough time on trouble shooting you eventually find the problem. I think I found the problem. When I would turn the key nothing. Little background. The engine wasn’t starting so I decided to get buy a new starter, due to the cost of a rebuilt. I was reading the starter number off the sales person of I boats dot com. He told me to stop, he replied, that is an auto starter not a marine. He then asked for the engine info. He then sent me a pic of the starter, (no solenoid attached) I told him yes and the starter came. I installed it and turned the key, w/ the plugs out, nothing. So I got a new solenoid. Took the old one out and took it to my local marine store, he got me a new one. In engaged when I turned the key, both cranks were weak, the third time nothing. I was then checking everything w/ a meter and doing the jumper thing trying to find the problem. The a friend told me, there are many different type solenoids. Made me realize I had the wrong solenoid (auto) for my new marine starter. I then looked it up on the I boat dot com website, and sure enough, it called for a different solenoid. I’ll order it tomorrow. I’m confident this will be the solution to my problem. I’ll keep you posted.
 

merit131

Seaman
Thread starter
Joined
Sep 20, 2011
Messages
58
Re: starter problem

Re: starter problem

Well the starter problem is solved. I had burnt out the new solenoid. So I purchased the correct solenoid for the new starter I installed and it cranked fine. So if you install a new starter and it?s not attached to the starter but to the engine, make sure you get the correct solenoid to match that starter. It will save you a lot of head aches and time going though all your wiring system. Thanks to all for you help. Jack
 

merit131

Seaman
Thread starter
Joined
Sep 20, 2011
Messages
58
Re: starter problem

Re: starter problem

Hi Guy's, here I am again w/ another starter problem. After all the was done (see above) New starter, solenoid, new ign switch. When I turn the key the starter engages to start the engine, but when I release the key, it stays engaged. I turn the key to off, and nothing, it still winding the engine. I changed the ign switch, and the solenoid, but nothing. I had to disconnect the battery. The starter in new as well. I assume I got a bad starter? What do you think? Thanks. Murf
 
Top