Quicksilver 3000 control problems.

B

boosted16v

Cadet
Joined
May 27, 2012
Messages
8
Im having a problem w my neutral safety switch on my quicksilver 3000 controls. When I hook both wires up as you should, two coming from switch, one going to harness the other to ignition switch, and turn the key, boat will not start. But If I by pass the switch and go straight from harness to switch, it fires right up..I dont know if it was bypassed from PO because I always put the boat into neutral from habit. My question is, Is it ok to run the boat like this? other than being able to start the boat in gear, will this hurt the boat in any way? I checked to make sure the boat was actually going into neutral by spinning the prop, and it is..So im guessing the switch is bad.
 
Don S

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: Quicksilver 3000 control problems.

It won't damage the electrical system or the engine or anything mechanical. It's only a safety issue.
 
B

boosted16v

Cadet
Joined
May 27, 2012
Messages
8
Re: Quicksilver 3000 control problems.

Thanks for the fast reply Don..then im callin it done and am gonna finish putting this boat back together!
 
You must log in or register to reply here.
Top