Painting out drive

[1979 Quartermasters]

Thx. In that kit I bought, there is an etching liquid called Power Blast.

It is a Zinc phosphate etcher/cleaner.

 

[Scott Danforth]

I prefer alumiprep

However If you just blasted the case, scuff with scotchbrite, wipe with acetone, then once that flashes, spray the etching primer.

 

[1979 Quartermasters]

Hey Scott, I noticed, on another thread, that you said bare aluminum has to be primed with in hours of being stripped. I have been stripping mine a bit at a time over the last week and intend on painting it this weekend. There is a chance I may not get to it , though. Does it harm the aluminum to leave it bare, or do I just need to light sand the whole thing and clean it before I paint. The lower is done and turned out quite nice. Just hope the paint stays on.

Ken

 

[tpenfield]

Got Pictures ???

 

[1979 Quartermasters]

 

[StingrayMike]

That looks nice, Good Job!

 

[1979 Quartermasters]

That looks nice, Good Job!

Thx

 

[1979 Quartermasters]

This is how it started out!

Ken

 

[RaceCarRich]

Nice job!

Scott,
“primer surfacer/sealant (either spray on or brush on) - this will seal the zinc primer and make a good base for top coat”

is this intermediate coat necessary and, if so, is there one you recommend?

 

[1979 Quartermasters]

Finally got that thing stripped. What a pain. Sand the whole thing and wipe with acetone then paint.

Tomorrow. Had enough for today!

Ken