John Wasmuth
Seaman Apprentice
Thread starter- Joined
- Feb 3, 2012
- Messages
- 32
I should have left well enough alone. Yesterday I took the plunge and put new points and condensers on the 1971 Evinrude 25102s. I had it running pretty well before the change. I got a timing fixture from Franks outboard tools and lined it up to the marks like its supposed to be. I put in the new points and condensers and set them accordingly. Wouldn't start. Readjusted everything and still nothing. No spark. Readjusted everything and then only to top plug. Readjusted everything and then spark only to bottom plug. Readjusted everything and then spark to both plugs. The marks on the plate and the tool are no where close to each other. Its right back where it was at about an inch and a half after TDC? Is this a normal thing? I wouldn't think it was.
But it does run. It also appears to have a lot more smoke blowing out of it. When you change out points and condensers do you then also have to adjust the carb and throttle linkage?
But it does run. It also appears to have a lot more smoke blowing out of it. When you change out points and condensers do you then also have to adjust the carb and throttle linkage?