Need Help Johnson 1967 6hp

RVSardou

Recruit
Thread starter
Joined
Sep 5, 2017
Messages
4
I have a Johnson 1967 6hp that is 'hard' to start when it's cold. The only way I can get it to start is by using an electric drill on the fly wheel. After it starts and has been running for a little bit, it starts perfectly fine all the time.
 

tomhath

Master Chief Petty Officer
Joined
Dec 5, 2007
Messages
814
What's your normal starting procedure? Full choke and throttle opened to Start position?

Make sure the choke is actually closing all the way.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
Are you squeezing the primer bulb till firm before you try to start it?
Have you done a compression test?
Spark to both cylinders?
Ignition system in good condition, as in good coils, condenser, points properly gapped and in good condition?
Float set correctly in carb?
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Do the usual spark and compression checks and see what you have (use an adjustable open air spark tester, and look for about 3/8" sharp spark.) If spark is weak, figure on ignition work. If the motor is new to you, should pull the flywheel and check the ignition coils. Replace them if casings are cracked. Clean and adjust points. Proper plugs are probably Champion J4C gapped to .030, but should check. Replace the impeller.

Fresh fuel (50:1 OK). If it's stubborn when cold (slow to warm up), think about replacing the t.stat -- or make sure it has one.
 

RVSardou

Recruit
Thread starter
Joined
Sep 5, 2017
Messages
4
I've done all of the above suggestions. I will recheck the spark again.

How do I check the strength of the magnets in the fly wheel?
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
I just dangle a small screwdriver in front of the magnets. Air gap between coils and magnets is important -- coils have to be mounted perfectly flush with mounting bosses.
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
You mentioned starting at START on the throttle. Any improvement if you give it more throttle? Those markings are a rough guide, at best.

How is compression? Hard starting is often a sign of low compression. You mentioned it had been checked, but what were your readings?
 
Top