2017 Chap 246 SSI
I'm putting in a through hull water inlet for engine cooling purposes because the Bravo 3 water inlet system stinks.
Anyways, I cut a hole in the floor and removing the foam. After removing the foam the hull of the boat looks like the pic below.
However the floor of the hull is not flat, it is curved. I'm assuming that the curves represent stringers correct?
Am I OK to put the thru hull in where the red rectangle is? It's the only even flat surface inside that I can find so far. Should I drill a small test hole first?
I already left a message for Chaparral about getting a schematic showing stringers but they haven't responded.
I'm putting in a through hull water inlet for engine cooling purposes because the Bravo 3 water inlet system stinks.
Anyways, I cut a hole in the floor and removing the foam. After removing the foam the hull of the boat looks like the pic below.
However the floor of the hull is not flat, it is curved. I'm assuming that the curves represent stringers correct?
Am I OK to put the thru hull in where the red rectangle is? It's the only even flat surface inside that I can find so far. Should I drill a small test hole first?
I already left a message for Chaparral about getting a schematic showing stringers but they haven't responded.