Motor

[Chuck4741444]

I have rebuild my transom on 1996 keener 21 ft CC then I Installed the motor, its not right because the left rear digs deep when I take off and the rooster tail sprays high on the right side. Im going to install a jack plate and bigger motor, I. Going to plug the top holes, how do I measured the get the motor online with my boat? I measured across the top, and that didn't work. Thanks

 

[roscoe]

I'm wondering if the motor is off center, horizontally, port to starboard?

OR... Is the motor not perpendicular to the water surface?

 

[Chuck4741444]

I'm wondering if the motor is off center, horizontally, port to starboard?

OR... Is the motor not perpendicular to the water surface?

I can see if the holes are centered on the transon, making sure the motor Is centered horizontaly, just pulled the old motor. Im waiting on lift plates,
How would I know if the motor is not on the boat vertically, not leaning to one side a fraction of an inch?