FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Here are a couple pictures of my motor box that I am upholstering. I did not have any problems with the top and front but the sides are posing a challenge in getting the puckers out especially where the angles are on the front. I have installed the beading along the edge and have the small strips of card board that help keep a straight edge when the material on the side is stapled on from underneath the material. I have cut the material for the sides oversized but should I cut it to shape on those angles? If you have done this before do you have any hints?
