Milky oil

[Lou C]

Most of the rocker arm studs you can buy aftermarket like ARP, etc are designed for the adjustable style, I am guessing that for performance builds people want the adjustable feature. So if you wanted the rocker arm studs for the non-adjustable style you might need to go with OEM.
The later Vortecs that have the roller rocker bearings, have a totally different style, there is a bolt that goes through the roller rocker assembly to retain the whole works, no stud like the earlier styles.

 

[SeaRayboater95]

Hey People, just wondering if there is an up or down When placing this gasket on the block. The only marking is Marine on one side. Both sides are not the same.

Thanks,

Ken

 

[Lou C]

I used Fel Pro on mine, trying to remember from when I did it like 9 years ago...both cylinder heads are actually the same casting. Try it both ways, see if it fits better one way vs the other. Does it seem to line up better with the Marine label showing?
Also before you bolt up those heads, make sure the cyl head bolt threads are CLEAN CLEAN CLEAN and that the bolts all thread all the way in!

 

[SeaRayboater95]

Also before you bolt up those heads, make sure the cyl head bolt threads are CLEAN CLEAN CLEAN and that the bolts all thread all the way in!

Done, done and done!

 

[alldodge]

In most cases the label faces up or they have an imprint listing top

 

[SeaRayboater95]

Hey Guys and Gals. Got her back together and running Ning nicely. Not sure where to put the timing mark..

Ken

 

[Lou C]

Congrats! Looks like you got it set to TDC or zero, I set mine at 6*BTDC using 89 octane gas; not sure if Merc used a different setting than OMC.

 

[SeaRayboater95]

Congrats! Looks like you got it set to TDC or zero, I set mine at 6*BTDC using 89 octane gas; not sure if Merc used a different setting than OMC.

Thanks. There's no marks on that tab. Which way do I go and how far? Is each notch a degree? Do I have to be in the water to set it.

 

[Lou C]

the bottom pic makes it more clear...the distributor has to be in timing mode and engine idling @ about 600 rpm, warmed up, can do it on the water hose...you're setting it at before top dead center @ whatever degrees Merc specifies in the manual.

 

[SeaRayboater95]

View attachment 420533
View attachment 420534the distributor has to be in timing mode

Thanks for that. The manual does not mention this and Don S in a previous post says the Thunderbolt IV does not require this step.

Ken

 

[Lou C]

Maybe that step is only needed with the Delco EST, I still have a points distributor, so I still do it the old way!
If you have an advance timing light, it’s a good idea to check the total timing advance as well. Merc probably has a graph showing how much advance at what RPM in the manual.
I've had this one for about oh, 45 years or so!

 

[nola mike]

Thanks for that. The manual does not mention this and Don S in a previous post says the Thunderbolt IV does not require this step.

Ken

It doesnt