Leaky strake on 2004 Chaparral

Stillcrazy

Seaman Apprentice
Thread starter
Joined
Jan 18, 2011
Messages
34
Re: Leaky strake on 2004 Chaparral

i had Gelcoated many bilges and interiors with a "Brush" and had acceptable results. I thought that maybe plastic on top might give me a smooth finish. I was wrong.It made a mess.I had to sand it out.
I didn't want to use my Automotive touch up gun so The Next step was to go down to the store and buy a Preval spray system. Uncertain from what I had read about it, I tried it anyway. For a few bucks I gave it a try. It had a hard time pushing a 10% reduced Gelcoat out. I was expecting orange peel...and i got it ! but It sanded out and polished beautifully.
Epoxy leaves an amine film that must be washed off before coating. I hope that I scrubbed it enough before Gelcoating !
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
Re: Leaky strake on 2004 Chaparral

Epoxy leaves an amine film that must be washed off before coating. I hope that I scrubbed it enough before Gelcoating !

Gel coat doesn't stick all that well to a very well prepared epoxy surface, so if all you did was scrub off the blush it may flake off.
 

Stillcrazy

Seaman Apprentice
Thread starter
Joined
Jan 18, 2011
Messages
34
Re: Leaky strake on 2004 Chaparral

I followed Gougeon's instructions and they said get rid of the "Blush" and scrub surface with a scruby pad and roughen it up. I made sure that it was rough. It is now November and in Florida that means low tides and windy weather. The rain nagged on into the fall and set a record for the wettest in a decade. I tested the boat several times and no water leak and examined the repair. It looks good. We will see !
 

Stillcrazy

Seaman Apprentice
Thread starter
Joined
Jan 18, 2011
Messages
34
Re: Leaky strake on 2004 Chaparral

Finished strake31207.jpg

The finished strake
 
Last edited:
Top